Go to the source code of this file.
◆ BOARD_INFO_NAME
#define BOARD_INFO_NAME "FYSETC AIO II" |
Marlin 3D Printer Firmware Copyright (c) 2019 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
Based on Sprinter and grbl. Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm
This program is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation, either version 3 of the License, or (at your option) any later version.
This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details.
You should have received a copy of the GNU General Public License along with this program. If not, see http://www.gnu.org/licenses/.
◆ BOARD_WEBSITE_URL
#define BOARD_WEBSITE_URL "fysetc.com" |
◆ DISABLE_JTAG
◆ pins_v2_20190128
◆ FLASH_EEPROM_EMULATION
#define FLASH_EEPROM_EMULATION |
◆ EEPROM_PAGE_SIZE
#define EEPROM_PAGE_SIZE uint16(0x800) |
◆ EEPROM_START_ADDRESS
#define EEPROM_START_ADDRESS uint32(0x8000000 + 256 * 1024 - 2 * EEPROM_PAGE_SIZE) |
◆ E2END
◆ X_STOP_PIN
◆ Y_STOP_PIN
◆ Z_STOP_PIN
◆ FIL_RUNOUT_PIN
#define FIL_RUNOUT_PIN PB15 |
◆ X_STEP_PIN
◆ X_DIR_PIN
◆ X_ENABLE_PIN
◆ Y_STEP_PIN
◆ Y_DIR_PIN
◆ Y_ENABLE_PIN
◆ Z_STEP_PIN
◆ Z_DIR_PIN
◆ Z_ENABLE_PIN
◆ E0_STEP_PIN
◆ E0_DIR_PIN
◆ E0_ENABLE_PIN
#define E0_ENABLE_PIN PC13 |
◆ MOTOR_CURRENT_PWM_RANGE
#define MOTOR_CURRENT_PWM_RANGE 1500 |
◆ DEFAULT_PWM_MOTOR_CURRENT
#define DEFAULT_PWM_MOTOR_CURRENT {500, 500, 400} |
◆ HEATER_0_PIN
◆ HEATER_BED_PIN
#define HEATER_BED_PIN PC6 |
◆ FAN_PIN
◆ TEMP_BED_PIN
◆ TEMP_0_PIN
◆ SDSS