Marlin 3D Printer Firmware Copyright (c) 2019 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
Based on Sprinter and grbl. Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm
This program is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation, either version 3 of the License, or (at your option) any later version.
This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details.
You should have received a copy of the GNU General Public License along with this program. If not, see http://www.gnu.org/licenses/. Arduino Mega with RAMPS v1.4Plus, also known as 3DYMY version, pin assignments The differences to the RAMPS v1.4 are:
- Swap heater E0 with E1
- Swap pins 8 and 10. Bed/Fan/Hotend as labeled on the board are on pins 8/9/10.
- Change pins 16->42, 17->44 and 29->53 used for display.
Applies to the following boards:
RAMPS_PLUS_EFB (Extruder, Fan, Bed) RAMPS_PLUS_EEB (Extruder, Extruder, Bed) RAMPS_PLUS_EFF (Extruder, Fan, Fan) RAMPS_PLUS_EEF (Extruder, Extruder, Fan) RAMPS_PLUS_SF (Spindle, Controller Fan)
1.8.16