Go to the source code of this file.
◆ BOARD_INFO_NAME
#define BOARD_INFO_NAME "BIGTREE SKR 1.1" |
Marlin 3D Printer Firmware Copyright (c) 2019 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
Based on Sprinter and grbl. Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm
This program is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation, either version 3 of the License, or (at your option) any later version.
This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details.
You should have received a copy of the GNU General Public License along with this program. If not, see http://www.gnu.org/licenses/.
◆ X_MIN_PIN
◆ X_MAX_PIN
◆ Y_MIN_PIN
◆ Y_MAX_PIN
◆ Z_MIN_PIN
◆ Z_MAX_PIN
◆ X_STEP_PIN
◆ X_DIR_PIN
◆ X_ENABLE_PIN
#define X_ENABLE_PIN P4_28 |
◆ Y_STEP_PIN
◆ Y_DIR_PIN
◆ Y_ENABLE_PIN
#define Y_ENABLE_PIN P2_00 |
◆ Z_STEP_PIN
◆ Z_DIR_PIN
◆ Z_ENABLE_PIN
#define Z_ENABLE_PIN P0_19 |
◆ E0_STEP_PIN
#define E0_STEP_PIN P0_11 |
◆ E0_DIR_PIN
◆ E0_ENABLE_PIN
#define E0_ENABLE_PIN P2_12 |
◆ E1_STEP_PIN
#define E1_STEP_PIN P0_01 |
◆ E1_DIR_PIN
◆ E1_ENABLE_PIN
#define E1_ENABLE_PIN P0_10 |
◆ TEMP_BED_PIN
◆ TEMP_0_PIN
◆ TEMP_1_PIN
◆ HEATER_0_PIN
#define HEATER_0_PIN P2_07 |
◆ HEATER_1_PIN
#define HEATER_1_PIN P2_04 |
◆ FAN_PIN
◆ HEATER_BED_PIN
#define HEATER_BED_PIN P2_05 |
◆ SDCARD_CONNECTION
#define SDCARD_CONNECTION ONBOARD |
LCD / Controller
As of 20 JAN 2019 only the REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER display has been tested with these settings. It can be connected to the SKR using standard cables via the EXP1 and EXP2 ports. Other displays may need a custom cable and/or changes to the pins defined below.
The SD card on the LCD controller uses the same SPI signals as the LCD, resulting in garbage/lines on the LCD display during SD card access. The LCD code mitigates this by redrawing the screen after SD card accesses.
◆ ONBOARD_SD_CS_PIN
#define ONBOARD_SD_CS_PIN P0_06 |