thermistor_75.h File Reference

Go to the source code of this file.

Variables
const short temptable_75[][2]	PROGMEM

Variable Documentation

PROGMEM

const short temptable_75 [][2] PROGMEM

Marlin 3D Printer Firmware Copyright (c) 2019 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]

Based on Sprinter and grbl. Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm

This program is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation, either version 3 of the License, or (at your option) any later version.

This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details.

You should have received a copy of the GNU General Public License along with this program. If not, see http://www.gnu.org/licenses/. R25 = 100 kOhm, beta25 = 4100 K, 4.7 kOhm pull-up, Generic Silicon Heat Pad with NTC 100K thermistor

Many generic silicone heat pads use the MGB18-104F39050L32 thermistor, applicable to various wattages and voltages. This table is correct if this part is used. It's been optimized to provide good granularity in the 60-110C range, good for PLA and ABS. For higher temperature filament (e.g., nylon) uncomment HIGH_TEMP_RANGE_75 for increased accuracy. If higher temperatures aren't used it can improve performance slightly to leave it commented out.